• W-139 A/B, Dubai Maritime City, Dubai, UAE
  • sales@marineslind.com
  • 00971 506290616



Horizontally mounted machines often consist of a pump and a motor, but can also include other types of machines such as gearboxes and compressors. Regardless of the machine type, it is easy to measure and align with Easy-Laser® E420.


This program is used for alignment of vertical and flange-mounted machines, e.g. pumps, motors, gear, boxes. Shows centre offset, angular error and shim value at each bolt.


The value program can be used e.g. when one wants to measure as with dial gauges and to check bearing play or shaft load. With the standard equipment and completely normal set up on the machine!

The instrument has the following features :

  • Accurate measurement for 3 selectable frequency ranges.
  • Real-time measurement of the total vibration level and the Bearing Condition (BC), shown simultaneously.
  • Headphone set with volume control and high pass filter for bearing noise detection.
  • Listening to bearing sound while comparing the displayed BC value.
  • Measurement units and measurement presentation may be selected by the user from the following list :
    • g ( RMS, Peak or P-P )
    • mm/sec ( RMS, Peak or P-P
    • μm ( RMS, Peak or P-P )
    • inch /sec ( RMS, Peak or P-P )
    • mils ( RMS, or P-P )
  • Bearing Condition measurement in a wide frequency range ( 0,5-30 khz).
  • Built-in infrared temperature sensor, units in *C or *F.
  • Bar indicator shows measurement stability.
  • Fast and easy fault analysis displaying the largest amplitude peak frequency in CPM or Hz in main screen display.
  • Large dynamic range of the vibration signal ( up to 50 g ).
  • High performance accelerometer.
  • Clear vibration, temperature and danger alarms by red and yellow colour LED’s.
  • Advanced technology with DSP processor.
  • Dust and waterproof, for rough use ( IP 65 ).

Request a call back

For information regarding our services and partnerships, please fill the form: